Disabled bed

Marlin/Configuration.h

@@ -89,7 +89,7 @@
 #define STRING_CONFIG_H_AUTHOR "JTH, ALLTED" //Who made the changes.
 #define SHOW_BOOTSCREEN
 #define STRING_SPLASH_LINE1 SHORT_BUILD_VERSION // will be shown during bootup in line 1
-//#define STRING_SPLASH_LINE2 STRING_DISTRIBUTION_DATE // will be shown during bootup in line 2
+#define STRING_SPLASH_LINE2 STRING_DISTRIBUTION_DATE // will be shown during bootup in line 2
 
 // @section machine
 
@@ -190,7 +190,7 @@
 #define TEMP_SENSOR_1 0
 #define TEMP_SENSOR_2 0
 #define TEMP_SENSOR_3 0
-#define TEMP_SENSOR_BED 1
+#define TEMP_SENSOR_BED 0
 
 // This makes temp sensor 1 a redundant sensor for sensor 0. If the temperatures difference between these sensors is to high the print will be aborted.
 //#define TEMP_SENSOR_1_AS_REDUNDANT
@@ -447,7 +447,7 @@ const bool Z_MIN_PROBE_ENDSTOP_INVERTING = true; // set to true to invert the lo
 
 // Enable Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN to use the Z_MIN_PIN for your Z_MIN_PROBE.
 // The Z_MIN_PIN will then be used for both Z-homing and probing.
-//#define Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN
+#define Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN
 
 // To use a probe you must enable one of the two options above!