-
Hi, I observe a message, which is actively requested by a According to the documentation and assuming, all message have the same poll priority (for me it is) the minimum time period can be estimated by
In my case I found 160 messages and 6 seconds between two poll-read messages. So at least 16 minutes. Increasing the poll priority to
What can I do with the means of configuration and options to reduce the overall time of the long running poll cycle? 1.Reduce the pool intervall between two read request using `--pollsec' The first option isn't a solution. It stresses the bus. Any hints are welcome. logs
|
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 2 replies
-
I think settings three type of prioroty r1 for most wanted information, r[2-4] for wanted but not so hot information and r9 for less wanted informaton (every other) will help to reduce time. But you can still comment all unwanted requests with hash. |
Beta Was this translation helpful? Give feedback.
-
Hi,
At first I figured out, why so many messages (160) are actively read in a poll cycle though no message is configured for active polling. All messages are of type But If you use an MQTT Integration with e.g. Home Assistant, than there is an auto polling for all matching messages according to the filter configuration in the config file To disable auto polling you have to change the default value of the
That's it. After restart the daemon I don't see any active poll requests!! Log extract
|
Beta Was this translation helpful? Give feedback.
Hi,
I got a solution. Now I suppress active polling as default and enable active polling only for messages
At first I figured out, why so many messages (160) are actively read in a poll cycle though no message is configured for active polling. All messages are of type
r
. According to the wiki, I expected that there is no active message polling at all.But If you use an MQTT Integration with e.g. Home Assistant, than there is an auto polling for all matching messages according to the filter configuration in the config file
mqtt-hassio.cfg
. And I run that integration!To disable auto polling you have to change the default value of the
fi…