-
Notifications
You must be signed in to change notification settings - Fork 70
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Emitter LED #23
Comments
Each code (receiver code and emitter code) has a ASCII drawing on how to
connect the led at its top. For the emitter, you'll need one arduino, wired
to a led through a current limiting resistor, and for the receiver, another
arduino with a led wired to an analog port with a parallel led.
Jonathan Piat
Le 24 févr. 2017 6:10 PM, "4cho" <notifications@github.com> a écrit :
… Dear Jpiat,
How did you connect wires to the emitter LED and how many arduino mini is
need in emitter circuit? I am using the same emitter LED like you but i
can't figure out how to connect to the arduino. Actually, I cant see any
pin on emitter LED.
—
You are receiving this because you are subscribed to this thread.
Reply to this email directly, view it on GitHub
<#23>, or mute the thread
<https://github.com/notifications/unsubscribe-auth/ACNWZJwJoe1xS4bVHf5Q_Q_4ZTys4pQdks5rfw8IgaJpZM4MLctv>
.
|
First of all, thanks for your replay, Jonathan. I saw the ASCII drawing and it is really helpful. For the emitter LED, did u drilled or open the LED to connect the wire inside because I bought the LED which is AC power supply since I can't find another emitter LED like the one you are using. |
You first need to use a plain old 5 or 3mm led dot not start with a LED
bulb. To use a LED bulb, i had to make major modifications to it.
2017-02-24 18:28 GMT+01:00 4cho <notifications@github.com>:
… First of all, thanks for your replay, Jonathan. I saw the ASCII drawing
and it is really helpful. For the emitter LED, did u drilled or open the
LED to connect the wire inside because I bought the LED which is AC power
supply since I can't find another emitter LED like the one you are using.
—
You are receiving this because you commented.
Reply to this email directly, view it on GitHub
<#23 (comment)>, or mute
the thread
<https://github.com/notifications/unsubscribe-auth/ACNWZKFCy3xHyvqze13QerTCz1gAJ33zks5rfxMngaJpZM4MLctv>
.
|
OH... I see. I was trying to figure out how to use that led bulb. 😆 Thank you for your advise, sir. 👍 |
for the time being, I am using such the LED in the link below. |
Dear Jpiat,
How did you connect wires to the emitter LED and how many arduino mini is need in emitter circuit? I am using the same emitter LED like you but i can't figure out how to connect to the arduino. Actually, I cant see any pin on emitter LED.
The text was updated successfully, but these errors were encountered: