You should see in monitor if the TXT Address is different to 0x00, this mean that is function ok, if not, check your wired or NRF24L01 + module.
| NRF24L01+ | Arduino (Mega 2560) |
|---|---|
| GND | GND |
| VCC (3.3V) | VCC (3.3V) |
| CE | 9 |
| CSN | 10 |
| SCK | 52 |
| MOSI | 51 |
| MISO | 50 |
SSTATUS = 0x0e RX_DR=0 TX_DS=0 MAX_RT=0 RX_P_NO=7 TX_FULL=0
RX_ADDR_P0-1 = 0xf0f0f0f0d2 0xf0f0f0f0e1
RX_ADDR_P2-5 = 0xc3 0xc4 0xc5 0xc6
TX_ADDR = 0xf0f0f0f0d2
RX_PW_P0-6 = 0x20 0x20 0x00 0x00 0x00 0x00
EN_AA = 0x3f
EN_RXADDR = 0x02
RF_CH = 0x4c
RF_SETUP = 0x07
CONFIG = 0x0e
DYNPD/FEATURE = 0x00 0x00
Data Rate = 1MBPS
Model = nRF24L01+
CRC Length = 16 bits
PA Power = PA_MAX
13!