Cloned from Klusjesman, modified to work on Arduino and ESP8266 with Arduino IDE
Will work with a 868MHz CC1101 module. The CC1150 may also work, except for receiving (which is not required for controlling an Itho EcoFan). A 433MHz CC1101/CC1150 might also work, because it has the same chip. But a 433MHz CC11xx board has a different RF filter, causing a lot less transmission power (and reception).
Connections between the CC1101 and the ESP8266 or Arduino:
CC11xx pins ESP pins Arduino pins Description
* 1 - VCC VCC VCC 3v3
* 2 - GND GND GND Ground
* 3 - MOSI 13=D7 Pin 11 Data input to CC11xx
* 4 - SCK 14=D5 Pin 13 Clock pin
* 5 - MISO/GDO1 12=D6 Pin 12 Data output from CC11xx / serial clock from CC11xx
* 6 - GDO2 ? Pin ? Programmable output
* 7 - GDO0 ? Pin ? Programmable output
* 8 - CSN 15=D8 Pin 10 Chip select / (SPI_SS)
Note that CC11xx pins GDO0 and GDO2 are not used (yet).
You should keep the wires to the CC11xx module as short as possible.
Beware that the CC11xx modules are 3.3V (3.6V max) on all pins! This won't be a problem with an ESP8266, but for Arduino you either need to use a 3.3V Arduino or use levelshifters and a separate 3.3V power source.
For use with an ESP8266, you will need the ESP8266 core for Arduino from https://github.com/esp8266/Arduino
For SPI, pins 12-15 ()aka D5-D8) are used, a larger ESP8266 model like (but not only) the ESP-03, ESP-07, ESP-12(D, E) or a NodeMCU board is required.