Sinamics-S120-Motion-Control-with-S7-1500-and-TIA-Portal

Control Sinamics S120 drive motion using Simatic S7-1500 and TIA Portal software.

In this example, a drive unit is to be assembled for a motor. The following components are required for the drive unit:

1.Control Unit CU 310-2PN

2.Power Module PM 240-2

3.Synchronous Servo Motor of 1FK7 family

4.Motion-Connect Drive-Cliq Cable

5.Motion-Connect Power Cable

6.Memory Cards

7.Simatic S7-1500

The following prerequisites must be fulfilled before you start:

1.The CompactFlash Cards with firmware must be inserted into S7-1500 and CU 310-2PN.

2.The drive components are wired by means of Drive–Cliq.

3.The Control Unit must be connected to S7-1500 via PROFINET.

4.The PROFINET interface of S7-1500 is connected to a PC through PROFINET cable.

5.The Control Unit must be configured using STARTER software.

6.The TIA Portal V15.1 software must be installed on your PC.

Download setup file (.ap15_1) onto S7-1500 and Go Online.

For more information on configuration, refer to https://blog.netpie.io/archives/6791