LightTracker Plus is an ESP32-based development board featuring a 1 Watt SX1268 (433MHz) LoRa module, GPS module, battery holder, and 2 dBi 433 MHz SMA antenna.
LightTracker Plus is available on https://shop.qrp-labs.com/aprs/lighttrackerplus for order.
Important : LightTracker Plus 1.0 operates on the amateur 70 cm (UHF) radio band with a 30 dBm output power, which typically requires an amateur radio license to operate in many countries. Therefore, if you are not a licensed HAM operator, please ensure to check local regulations and laws before purchasing the module.
- Low Power Consumption Capability (Deep Sleep)
- Powerful (1 Watt) LoRa Radio Module
- Compact GPS Module Integrated with Patch Antenna
- GPS Balloon mode, for high altitude up to 80km (Convenient for High Altitude Balloon tracking)
- 18650 Battery Holder with charging capability (Battery not included)
- Suitable for Open Source HAM Radio ESP32 projects like Meshtastic, TinyGS, LoRa APRS Tracker & iGate, etc
- Shipped with preloaded basic LoRa APRS Software(Tracker, iGate or Digipeater)
- TinyGS compatible (still testing), check out this page for details.
- 0.96 inch OLED Screen (VCC,GND,SCL,SDA) support (OLED screen not included)
- 3D Models (stl files) for printing board case (Case not included)
- Software : Open Source
- Weight : 40 grams
- Dimensions : 99.9 mm x 40.9 mm x 26 mm
- IDE : Arduino & VSCode
- Platform : ESP32
- CPU : ESP32-S3 MINI
- Flash : 8 MB
- Ram : 512 kB SRAM
- Operating Frequency : 240 Mhz
- Operating Voltage : 3.3 Volt
- Input Voltage : 3.3 (min) - 5.5 (max) Volt via USB Type C 2.0 or Battery Holder
- Sensor : SHTC3 (humidity and temperature)
- Power Consumption (Deep Sleep) : ~0.2 mA
- Power Consumption (Idle) : ~65 mA
- LoRa Radio Module : EBYTE E22-400M30S (SX1268)
- LoRa Operating Frequency : 410~493MHz (configurable by code)
- LoRa Max Power : 30dBm (configurable by code)
- LoRa Power Consumption (TX) : ~650 mA (30dBm)
- GPS : Quectel L80RE-M37 (GPS-QZSS)
- Extended Pins : I2C, I2S (in gpio pins, you can select random pins to use for I2S ), SPI, UART, 14x GPIO Pin(includes SPI, Analog pins, Touch pins), 4x Analog, 3x TOUCH, 2x CLK_OUT (in uart0 pins)
If you have any questions or need support, please contact support@lightaprs.com