Linux 802.11n CSI-Tool monitor-mode send and receive packet at the same time

Usage

This code is based on Linux 802.11n CSI Tool. Make sure you have installed it and can use it properly. http://dhalperi.github.io/linux-80211n-csitool/.

This code runs in the monitor mode of Linux 802.11n CSI Tool,download this code and replace to "linux-80211n-csitool-supplementary/injection" folder.

1. Run commands under "linux-80211n-csitool-supplementary/injection" folder:

sudo chmod +x setup.sh
make
sudo ./setup.sh 64 HT20
sudo ./random_packets 1000 100 1 1000

2. Open a new terminal,Run commands under "linux-80211n-csitool-supplementary/netlink" folder:

sudo ./log_to_file csi_data.dat

3. Repeat this on another computer with Linux 802.11n CSI Tool .Bidirectional CSI acquisition requires two computers equipped with CSI Tools.

Screenshot

Notice

This code work well under Ubuntu 12.04, download address http://releases.ubuntu.com/12.04.5/

Linux 802.11n CSI Tool 监控模式下双向CSI采集（同时发送并接收数据）

使用

此代码基于Linux 802.11n CSI Tool,请确保你已经安装并可以正常使用 http://dhalperi.github.io/linux-80211n-csitool/.

此代码运行在Linux 802.11n CSI Tool的监控模式下，下载此代码并替换到 linux-80211n-csitool-supplementary/injection 文件夹下.

1. 在 linux-80211n-csitool-supplementary/injection 文件夹下运行以下命令:

sudo chmod +x setup.sh
make
sudo ./setup.sh 64 HT20
sudo ./random_packets 10000 100 1 10000

2. 打开一个新的终端，在linux-80211n-csitool-supplementary/netlink 文件夹下运行以下命令:

sudo ./log_to_file csi_data.dat

3. 在另一台安装有Linux 802.11n CSI Tool 的计算机上重复上述操作. 双向CSI采集需要两台安装有CSI Tool的计算机.

截图

说明

此代码在Ubuntu 12.04下测试通过，下载地址 http://releases.ubuntu.com/12.04.5/