C811 baseline

[kwoerdehoff]

Hello!
Made a Projekt with the CJMCU-811 (C811 with HDC1080, Temp&Humid).
Made a Sketch with your Library and its running so far.
While running the Datas about eCo2 and eTVOC is getting higher and higher and jumps up and down.
So i tried to get Informations about this. I found an german Article about the C811 and its "Baseline".
Is there any CodeExample for putting and rerwiting the Baseline in and out of the EPROM?
Iám no Programmer, so i need an Example to put it in my Code.
Would be verry nice to get Help.

;_)) Klaus

[maarten-pennings]

Hi,

To save and restore the baseline is easy.
The hard part is when.
There are several issues about baseline management in this GitHub project.
For example, see #22 (comment)

[kwoerdehoff]

Hello Maarten, have been on Vacation. Thanks a lot for your help. Will look at it and tell you what happens.   Best Regards ;_)) Klaus     Gesendet: Dienstag, 04. Oktober 2022 um 22:31 Uhr Von: "Maarten Pennings" ***@***.***> An: "maarten-pennings/CCS811" ***@***.***> Cc: "kwoerdehoff" ***@***.***>, "Author" ***@***.***> Betreff: Re: [maarten-pennings/CCS811] C811 baseline (Issue #72)   Hi, To save and restore the baseline is easy. The hard part is when. There are several issues about baseline management in this GitHub project. For example, see #22 (comment) — Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you authored the thread.Message ID: ***@***.***>