Guidelines for Extension
Joshua Vasquez edited this page Mar 17, 2020
·
2 revisions
Jubilee has space constraints!
If you are designing a new tool, have a look at the Tool Interface Diagram to get a picture of the maximum allowable tool dimensions.
- Connecting to Jubilee
- Pre-Flight Checks
- Dialing in Parking Post Locations
- Mesh Bed Leveling
- Bed Heater Tuning
- Extruder Heater Tuning
- Setting Tool Offsets
- General Maintenance
- [Tool Plate Disc Replacement]
- [Twist Lock Pin Replacement]
- [Avoiding Loose Screws]
- Bondtech Direct-Drive Extruder
- [E3D Hemera]
- [Passive Pen Tool]
- [Magnetic Bed]
- Flagging Issues
- Adding to the Wiki
- [Adding a Shopping List]
- [Adding a Tool]
- [Adding a Bed Plate]
- Pushing Changes to the Hardware Design
[Acknowledgments]