MKS SERVO42B User Manual
Based on the open project of nano_stepper by Misfittech:https://github.com/Misfittech/nano_stepper.
To improve performance, Makerbase Team has made the following changes:
- Ported the project to STMicroelectronics' 32-bit MCU, STM32F103C8T6 ARM 32-bit Cortex™-M3 CPU Core,72 MHz maximum frequency,20k RAM. 64k Flash
- Changed the magnetic encoder to Allegro's A1333LLETR-T Contactless 0° to 360° angle sensor IC ,12bit
- Ported the compilation platform from arduino to PlatformIO —— Convenient for STM32 MCU compilation
- Change the socket with motherboard, now it can work with much 3D printer motherboards using MKS SV_EXT V1.1 by Makerbase
This project support build and upload by platformio, you can use Atom or Code editor (need install platformio) build it or upload firmware. Please refer to the following method:
ATOM editor
Open platformio.ini file, set default_envs = mks_servo42b
VSCode editor
Open platformio.ini file, set default_envs = mks_servo42b
You can use jlink or stlink upload firmware,the two upload methods are just different in platformio.ini settings
Use jlink,you need upload_protocol = jlink
Use stlink,you need upload_protocol = stlink
Use jlink connect MKS SERVO42B
Need to connect jlink's SWDIO,SWCLK,RESET,GND to MKS SERVO42B motherboard's SWDIO,SWCLK,RESET,GND.
If you are using jlink for the first time, you may need to install the driver,Upload firmware by jlink
,jlink connect PC Because MKS SERVO42B motherboard encrypted by Jflash,we need unsecure chip Usecure chip by Jflah
Upload firmware by jlink
Upload firmware success, we need reinstall the motherboard on the back of the motor.
MKS SERVO57B upload firmware similar operation.If you have any problems, you can feedback to us and we will assist to solve it.
**Note: ** For the V1.0 version, you may need to remove the board from the motor, because the programming interface is located on the bottom of the PCB. Sorry for the mistake, we have improved in subsequent versions.
https://www.aliexpress.com/item/33032696338.html?spm=a2g0o.store_home.productList_8356958.pic_1
The hardware is under the Creative Commons Attribution Share-Alike 4.0 License as much of the work is based on Mechaduino project by J. Church. https://github.com/jcchurch13/Mechaduino-Firmware.
The firmware is based on nano_stepper project by Misfittech：https://github.com/Misfittech/nano_stepper, which is licensed as GPL V3 for non-commercial use. If you want to release a closed source version of this product, please contact MisfitTech.net for licensing details.