Board not installing Marlin

[tatoap3]

Hi!

Anyone knows if on SGEN_L V2.0, if I want to use DIR/Step mode, I connect the same mode as you show on other boards? M0 M1 and M2 jumped with the pin on the middle? And on this mode do I need to use 5 or 3,3V? I use TMC2209 drivers.

[mks-viva]

Hi!
If you use TMC2209 DIR/Step mode

1. You need use jumpers connect to motherboard's M0, M1; Driver IC power you can use 3.3V or 5V
   

If you use TMC2209 UART mode

1. Jumpers setting
   

2. If you use sensorless homing function, you need connect X-DIAG jumper and driver IC power connect to 3.3V
   

More information, you can refer to MKS SGEN_L V2 Wiki and link is: https://github.com/makerbase-mks/MKS-SGEN_L-V2/wiki

[mks-viva]

Is this problem solved?

[mks-viva]

Hi! I will close this issues temporarily.

[tatoap3]

Hi friend Sorry to don't reply I was trying to understand what is wrong, but I was without much time in the past weeks The printer I was trying to install didn't work with the board. I tried with the makerbase display and with the one I had in the original kit, but the motors don't move I seted the same vref it was in the previous kit, did all the connections right, checked over and over what could be wrong, but until now I don't know what can be... Now the printer is on one friend's home, if you can have a clue on what's wrong and need any information please, let me know, so I ask him to take a picture or check the information... The original kit was mounted with an arduino mega and a ramps 1.4 Thanks for all the attention so far and sorry again for the time I took to reply Best regards Otavio Em dom, 13 de dez de 2020 22:47, mks-viva <notifications@github.com> escreveu:

…

Hi! I will close this issues temporarily. — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#27 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ARYEZ72Q2EV7T245GRPNYKDSUVVC5ANCNFSM4TVWWEJA> .

[mks-viva]

I suggest you follow my instructions to test it