changed image sizes

README.md

@@ -2,6 +2,10 @@
 
 The single sided self etchable pcb is designed to power the ESP-module, has a reset and flash (program) button, the necessary pull-up/ pull-down resistors and a USB-to-serial IC (CH340G) to connect the adapter board via micro USB to the USB port on a PC. You can also wire a serial connection directly to the RX/ TX module pins.
 
+|
+---|---
+![image](https://github.com/markbeee/ESP8266_Breakout_Board/images/Board_ESP8266.jpg) | ![image](https://github.com/markbeee/ESP8266_Breakout_Board/images/Kit.jpg )
+
 Please bear in mind that the module pins have a 3.3 volt signal level. If you use a signal source with 5 volt (e.g. an Arduino driven by 5 volt) the RX-pin has to be driven by a voltage divider or any kind of level shifter.
 
 The module can be connected to a power source via USB, the Vcc-pin of the module (max. 3.6 volt) or via the Vin-pins (max. 12 volt, min. 4.8 volt).
@@ -12,6 +16,6 @@ The adapter can be placed on any breadboard and leaves one row on each side avai
 
 As the pcb is single sided you have to connect three jumper wires on the bottom (see Eagle-files for directions).
 
-![image](/images/Board_ESP8266.jpg )
 
-![image](/images/Kit.jpg )
+
+