treadstone48_buildguide_en.md

Treadstone48 Build Guide

List of parts

Parts included when buying the TS48 kit

Name	Quantity	Note
PCB	1
Mount Plate	1	FR4(PCB plate)
Acrylic Bottom Plate	1
Acrylic Pro Micro Cover	1
M2 spacer 8mm	2	use with Acrylic Pro Micro Cover
M2 spacer 7mm	8	use with Acrylic Bottom Plate
Plastic spacer 2mm	8	use with Acrylic Bottom Plate
M2 Screw 4mm	18
M2 Black Screw 4mm	2	Top use with Acrylic Pro Micro Cover
Rubber Feet	8
1N4148 diode	48
TRRS Jack	1	not use
Reset Switch	1

Please purchase separately (not included)

Name	Quantity	Note
MicroUSB cable	1
Key Switches	47～48	Compatible for MX
Key Caps	47～48	compatible for MX stem, Better than ANSI104 keysets
Pro Micro	1
Pin 12P	2	For use with Pro micro
Kailh MX Socket	47〜48	Kailh socket
Stabilizer	1～2	PlateMount
LED strip（WS2812B x6）	2	Underglow

Firmware

Treastone48 QMK Directory

Make example for this keyboard (after setting up your build environment):

make treadstone48:default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Soldering of Diodes

Steps.

• Lead Forming
• Insert in the through hole (Be careful of the direction of the diode)
• Soldering

Insert key switches to Mount Plate

The parts of the picture can be installed according to your preference.

Soldering of Sockets

A first, Combine the PCB and the mounting plate.
And then Insert the socket into the pin of the switch protruding from the PCB. (be careful with the orientation)
Solder the terminal and PCB of both ends of the socket.

Soldering of Pro micro

　Be careful with the orientation.

Soldering of Reset Switch

SOldering of LED Strip

　Be careful with the orientation.

Attach the Acrylic Cover

Use an 8 mm spacer, 2 4 mm screws and 2 4 mm black screws. Attach the cover to the PCB.

Install Acrylic Bottom Plate

　Use 8 spacers of 7 mm, 8 spacers of plastic and 16 screws of 4 mm. Remove the bottom plate protective paper and attach the PCB.