You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Sorry, newb here so please feel free to ask questions of me.
Raspberry PI 3 B, GPIOnext joypad, Arcade Game, Power Control System (Jaycar XC9062 and XC9064). Using current RetroPie build.
Steps taken:
Boot ok,
launches into EmulationStation,
press F4, as per included 1 page instruction;
sudo apt update,
sudo apt install git python3-dev -y,
git clone blah GPIOnext.git,
sudo ./install.sh
Follow all prompts to setup joystick, buttons, etc
gpionext test 1
All results seem correct and successful.
launch EmulationStation, Welcome screen, 1 Gamepad detected.
As soon as I press any key to configure device, “GPIOnext Joypad 1” on screen with “OK” below and that’s it. Nothing progresses except F4.
Please, pulling what’s left of my hair out, have honestly searched multiple forums, no close results.
Thank you kindly,
Ed.
The text was updated successfully, but these errors were encountered:
Forgive be, it's been a while since I've set up the controllers, but I
think that you have to press and hold a button. I can't remember if it's a
specific button or just any button.
On Mon, Apr 6, 2020, 11:41 PM Edward Cox ***@***.***> wrote:
Sorry, newb here so please feel free to ask questions of me.
Raspberry PI 3 B, GPIOnext joypad, Arcade Game, Power Control System
(Jaycar XC9062 and XC9064). Using current RetroPie build.
Steps taken:
Boot ok,
launches into EmulationStation,
press F4, as per included 1 page instruction;
sudo apt update,
sudo apt install git python3-dev -y,
git clone blah GPIOnext.git,
sudo ./install.sh
Follow all prompts to setup joystick, buttons, etc
gpionext test 1
All results seem correct and successful.
launch EmulationStation, Welcome screen, 1 Gamepad detected.
As soon as I press any key to configure device, “GPIOnext Joypad 1” on
screen with “OK” below and that’s it. Nothing progresses except F4.
Please, pulling what’s left of my hair out, have honestly searched
multiple forums, no close results.
Thank you kindly,
Ed.
—
You are receiving this because you are subscribed to this thread.
Reply to this email directly, view it on GitHub
<#37>, or unsubscribe
<https://github.com/notifications/unsubscribe-auth/ABRCRWKONYJB4HRMDH736MDRLLDJBANCNFSM4MC3ILIQ>
.
Sorry, newb here so please feel free to ask questions of me.
Raspberry PI 3 B, GPIOnext joypad, Arcade Game, Power Control System (Jaycar XC9062 and XC9064). Using current RetroPie build.
Steps taken:
Boot ok,
launches into EmulationStation,
press F4, as per included 1 page instruction;
sudo apt update,
sudo apt install git python3-dev -y,
git clone blah GPIOnext.git,
sudo ./install.sh
Follow all prompts to setup joystick, buttons, etc
gpionext test 1
All results seem correct and successful.
launch EmulationStation, Welcome screen, 1 Gamepad detected.
As soon as I press any key to configure device, “GPIOnext Joypad 1” on screen with “OK” below and that’s it. Nothing progresses except F4.
Please, pulling what’s left of my hair out, have honestly searched multiple forums, no close results.
Thank you kindly,
Ed.
The text was updated successfully, but these errors were encountered: