You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I sheathed my servo cables using a braided nylon sheath however I was unable to snake them through the servo cable hole in the upper leg. I ended up having to use a router to enlarge the hole and snake them through. The next issue then became the channel, particularly the area right there the servo sides, is super tight and causes some binding.
The text was updated successfully, but these errors were encountered:
Thank you for mentioning this, i will certainly adress this! Also I am actually already aware of this issue and have it on my todo list in the projects section of the 3d-printed-parts. I have encountered it too, while assembling my spotmicro using fabric-hoses around the servocables and did not think about it in the design process. I will keep this issue open as a reminder, but right now my priority is to make a documentation on the wiring/circuitry, because i think this is more urgent due to the lack of it.
I sheathed my servo cables using a braided nylon sheath however I was unable to snake them through the servo cable hole in the upper leg. I ended up having to use a router to enlarge the hole and snake them through. The next issue then became the channel, particularly the area right there the servo sides, is super tight and causes some binding.
The text was updated successfully, but these errors were encountered: