Soldering Iron
Solder
Side cutters
Wire strippers
Small screw driver
Requires the use of the following Arduino library
https://github.com/coryjfowler/MCP_CAN_lib
If you have the ability to, burn the new Arduino nano bootloader to the board.
Then program with can-receive-all sketch
Parts plus 2 core wire is required
If you have a 2022 v1.3 board please solder a bridge between the middle and the voltage of the Nano board you are using, orignal 328p boards use 5v the newer nano-every etc use 3.3v for the processor. THIS IS NOT SHOWN ON THE PICTURES BELOW.
PCB in holder
Board with Arduino nano
Board with Arduino nano with additional solder on USB plug
Rear of board with Arduino nano soldered in opposite corners
Rear of board with Arduino nano fully soldered
Rear of board with Arduino nano pins cut short
Rear of board with Arduino nano re soldered
Made board without pushing pins through
MCP2515 Module rear
MCP2515 some pins pushed through
MCP2515 all pins pushed through
MCP2515 module in place
MCP2515 module ready for solder
MCP2515 module top soldered
MCP2515 module without pin header plastic
MCP2515 module rear soldered and terminator jumper
ICSP header without plastic
ICSP header removed
OBD2 plug
OBD2 cable and drill
OBD2 cable twisted pair
Complete Top
Complete Rear
