You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have a module from a friend who wouldn't start soldering on it
Am now looking for the manual of this module
How and what needs to be soldered for a Pi4 to work with PoE
what software needs to be installed for this module to work
regards
carlo
The text was updated successfully, but these errors were encountered:
Hi,
Come back to our website and check tomorrow I release it, as it is still
under writing process, same with new firmware, daemons etc
BUT PLEASE use our new forum, _as this one is not monitored_
Regarding your question, you need to solder ONLY GOLD Pins PE and RUN,
and PoE Connector (4 pins) included in the package. Then install Daemon,
and ready. Please repeat this question on our new forum, so I will
answer again to you_
_
My Warmest Regards
Ioannis
On 02-Apr-22 1:54 PM, carlo-l wrote:
I have a module from a friend who wouldn't start soldering on it
Am now looking for the manual of this module
How and what needs to be soldered for a Pi4 to work with PoE
what software needs to be installed for this module to work
regards
carlo
—
Reply to this email directly, view it on GitHub
<#63>, or unsubscribe
<https://github.com/notifications/unsubscribe-auth/ACBH7BGLDLSX3ZLXOJCLCSLVDARNPANCNFSM5SKYTK5A>.
You are receiving this because you are subscribed to this
thread.Message ID: ***@***.***>
--
Ioannis
Pi Modules
Raspberry Pi Approved Design Partner
www.pimodules.com
--
Pi Modules Legal Disclaimer
The content of this email is confidential and solely intended for the indicated addressee. Access to this email by anyone else is unauthorized. If you are not the intended recipient be informed that disclosure, reproduction in any form, in part or whole, or circulation of the content of this email is prohibited and may be unlawful. In this case, please inform immediately the sender of the email.
I have a module from a friend who wouldn't start soldering on it
Am now looking for the manual of this module
How and what needs to be soldered for a Pi4 to work with PoE
what software needs to be installed for this module to work
regards
carlo
The text was updated successfully, but these errors were encountered: