You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I downloaded the files, installed them, switched the handshake off and it seemed to work. In the ACT module section on the main screen I see the 'MMCL Mackie Control #1 - 1' is selected. In the status box below I see the text 'Trks 1-8, Mstr 1, Jog:Meas'.
However, when I open the controller/surface properties panel I don't get any presets. Also when I click the ' Configure Layout' button in the bottom righthand corner nothing happens.
I checked the settings in the register, found two references configured for Shared Presets. When I open these folders I get a long list control surface files which are all without extension each approx 20kb so i guess they should show up as presets.
Furthermore, when I save a preset this filesname doesn't show up in any of the two preset folders, nor does it show up on any of the drives that are connected to my PC.
I tried this with the Mackie Control Universal protocol and the HUI (Beta protocol). I've tried everything I could think of but so far no success.
Any thoughts on this?
The text was updated successfully, but these errors were encountered:
Hi,
Very interesting topic. I own the Keylab 61 mkII
I downloaded the files, installed them, switched the handshake off and it seemed to work. In the ACT module section on the main screen I see the 'MMCL Mackie Control #1 - 1' is selected. In the status box below I see the text 'Trks 1-8, Mstr 1, Jog:Meas'.
However, when I open the controller/surface properties panel I don't get any presets. Also when I click the ' Configure Layout' button in the bottom righthand corner nothing happens.
I checked the settings in the register, found two references configured for Shared Presets. When I open these folders I get a long list control surface files which are all without extension each approx 20kb so i guess they should show up as presets.
Furthermore, when I save a preset this filesname doesn't show up in any of the two preset folders, nor does it show up on any of the drives that are connected to my PC.
I tried this with the Mackie Control Universal protocol and the HUI (Beta protocol). I've tried everything I could think of but so far no success.
Any thoughts on this?
The text was updated successfully, but these errors were encountered: