Implementation-of-Half-Adder-and-Half Subtractor-circuit
AIM:
To design a half adder and half subtractor circuit and verify its truth table in Quartus using Verilog programming.
Equipments Required:
Hardware – PCs, Cyclone II , USB flasher
Software – Quartus prime Theory Adders are digital circuits that carry out the addition of numbers.
Half Adder
Half adder is a combinational circuit that performs simple addition of two binary numbers. The input variables designate the augend and addend bits; the output variables produce the sum and carry. It is necessary to specify two output variables because the result may consist of two binary digits.
Sum = A’B+AB’ =A ⊕ B Carry = AB
Figure -01 HALF ADDER
Half Subtractor
The half-subtractor is a combinational circuit which is used to perform subtraction of two bits. It has two inputs, X (minuend) and Y (subtrahend) and two outputs D (difference) and B (borrow). To perform x - y, we have to check the relative magnitudes of x and y. If x ;;, y, we have three possibilities: 0 - 0 = 0, 1 - 0 = 1, and 1 - I = 0. The result is called the difference bit. If x < y, we have 0 - I, and it is necessary to borrow a 1 from the next higher stage. The I borrowed from the next higher stage adds 2 to the minuend bit, just as in the decimal system a borrow adds 10 to a minuend digit. With the minuend equal to 2, the difference becomes 2 - I = 1. The half-subtractor needs two outputs. One output generates the difference and will be designated by the symbol D. The second output, designated B for borrow, generates the binary signal that informs the next stage that a I has been borrowed.
Diff = A’B+AB’ =A ⊕ B Borrow = A’B
Figure -02 HALF Subtractor
Truthtable
Procedure
-
Type the program in Quartus software.
-
Compile and run the program.
-
Generate the RTL schematic and save the logic diagram.
-
Create nodes for inputs and outputs to generate the timing diagram.
-
For different input combinations generate the timing diagram.
Program:
/* Program to design a half adder and full adder circuit and verify its truth table in quartus using Verilog programming.
Developed by: RegisterNumber:*/
RTL Schematic
Output/TIMING Waveform
Result: