Segmentation Fault error while running as a superuser (previously on google group discussion) #725
-
Migrated from google group with the same topic here. Here's my github repo. I have checked on pingOut port and it's still connected to prmdb component. However, I realized I accidentally commented out the prmDb init in topology.cpp. This only solves one of the errors. all this remain now is
Note that I redacted the GDS IP address. Interestingly enough, it seem like it can connect to the GDS briefly. |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 3 replies
-
I realized that I didn't have schedin port connected so I put it in so I can have my component run as a part of rate group 1. The error shows is similar but shows an interesting message. EVENT: (147) (2:1623832937,528026) WARNING_HI: (PRM) PrmFileReadError : Parameter file read failed in stage 0 with record 0 and error 1 I could be wrong but I don't think prmdb is an issue here. I tried commenting out anything related to prmdb in topology but it just solves the parameter fail to read error. I'm wondering if anyone know where I can find the meaning behind fatal 341 or "Failed to open port with status -4 and errno 111". My repo is updated with the changes I made so far. FYI, I can cross compile Ref on the same machine to raspberry pi and run them without any problem so I don't think it's about port 50000. |
Beta Was this translation helpful? Give feedback.
-
The assert in |
Beta Was this translation helpful? Give feedback.
The assert in
F-Prime/Svc/Cycle/CyclePortAc.cpp
is occurring because the cycle port is not hooked up to anything. Are you usingDrv/BlockDriver
and is that component's cycleOut port hooked toRateGroupDriver
?