You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Taranis with a DIY DSM2 module (i.e., with a genuine Spektrum module cannibalized from a Spektrum DX4e) does NOT transmit when used with standard builds of v 2.0.10 or 2.0.11 of opentx-taranis-haptic-en as fetched by opentx companion.
However it transmits just fine with v 2.0.7 (opentx-taranis-haptic-en-2.0.7.bin).
How can I tell it's not transmitting rather than not binding? An RF monitor such as a kitchen microwave leak detector shows no power.
The text was updated successfully, but these errors were encountered:
Bsongis,
I downloaded the new (9/11/2014) opentx-taranis-haptic-en-2.0.11.bin and found that it differs from the opentx-taranis-haptic-en-2.0.11.bin downloaded on 9/10/2014.
The new file works just fine! Thanks so much for addressing this issue!
Taranis with a DIY DSM2 module (i.e., with a genuine Spektrum module cannibalized from a Spektrum DX4e) does NOT transmit when used with standard builds of v 2.0.10 or 2.0.11 of opentx-taranis-haptic-en as fetched by opentx companion.
However it transmits just fine with v 2.0.7 (opentx-taranis-haptic-en-2.0.7.bin).
How can I tell it's not transmitting rather than not binding? An RF monitor such as a kitchen microwave leak detector shows no power.
The text was updated successfully, but these errors were encountered: