FS#3566 - dlink 620 failsafe not reached

[openwrt-bot]

icegood:

• Device problem occurs on: D-Link DIR-620 Rev A1

• Software versions of OpenWrt/LEDE release : 19.07.5

• Steps to reproduce:

1. enter the failsafe mode accordingly to instruction
   https://openwrt.org/docs/guide-user/troubleshooting/failsafe_and_factory_reset-
   Note that button became blinking too fast.

2. Try to connect via LAN.

Expected result: notebook's eth will obtain ip from 192.168.1.1/24

Actual result:

• no ip address is obtained. Router still unreachable.
  -- Led is still blinking frequently (maybe OK).

More information: unreachable mode was obtained after playing around with relayd packet and config router to repeater mode accordingly to instruction
https://openwrt.org/docs/guide-user/network/wifi/relay_configuration

[openwrt-bot]

SAm0815:

As far as I know there is no DHCP-Server enabled in failsafe-mode at all. So you have to assign an IP_address manually to your notebook, e.g. 192.168.1.2/24. Then you should be able to SSH to the routers address (192.168.1.1).