You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
The edgerouter's kernel partition of 3MiB is getting to small for upcoming lts kernel 6.6.
Depending on how the following OpenWrt issue is resolved, we will likely need new factory images for the web gui at some point to allow for direct installation of the next major Gluon release (based on OpenWrt 24): openwrt/openwrt#15197
Without those we can still upgrade by sysupgrades but require an inbetween step of Gluon v2023.2 (OpenWrt 23.05).
A new factory install image based on OpenWrt 23.05 could be useful (it needs to contain the required sysupgrade change so it can install the new image to both kernel partitions (merged))
OpenWrt 23.05 is likely the last release able to do this. I can't imagine the stock rom being able to install the initramfs image to both partitions.
The text was updated successfully, but these errors were encountered:
root@7483c2f78e46:~# sysupgrade -n /tmp/gluon-ffac-v2023.2.2-1-ubiquiti-edgerouter-x-sysupgrade.bin
Device ubnt-erx not supported by this image
Supported devices: ubnt,edgerouter-x ubnt-erx ubiquiti,edgerouterx - Image version mismatch: image 1.1, device 1.0. Please wipe config during upgrade (force required) or reinstall. Reason: Config cannot be migrated from swconfig to DSA
Image check failed.
Even right now Gluon v2023.2 can't be installed from the offered web gui (config mode) because this installer image doesn't ignore minor compat increases, yet. (like Gluon does since Gluon v2022.1)
OpenWrt 23.05 increased minor compat release to 1.1 due to introduction of DSA which requires a network config reset (which Gluon does on every sysupgrade nowadays)
The edgerouter's kernel partition of 3MiB is getting to small for upcoming lts kernel 6.6.
Depending on how the following OpenWrt issue is resolved, we will likely need new factory images for the web gui at some point to allow for direct installation of the next major Gluon release (based on OpenWrt 24):
openwrt/openwrt#15197
Without those we can still upgrade by sysupgrades but require an inbetween step of Gluon v2023.2 (OpenWrt 23.05).
A new factory install image based on OpenWrt 23.05 could be useful (it needs to contain the required sysupgrade change so it can install the new image to both kernel partitions (merged))
OpenWrt 23.05 is likely the last release able to do this. I can't imagine the stock rom being able to install the initramfs image to both partitions.
The text was updated successfully, but these errors were encountered: