D-Link HNAP

This is an experimental integration to Home Assistant supporting D-Link devices. It communicates locally with the devices, i.e. no cloud needed, but only supports polling.

The following devices are supported:

• Motion Sensor (DCH-S150)
• Water Leakage Sensor (DCH-S160 and DCH-S161)

DISCLAIMER: Currently I don't use any of these devices. So I cannot test the integration. It is provided as reference and for the community to maintain. Please send PRs!

Installation

HACS (preferred method)

This integration is available in the default repository list, just search for it!

Manual install

Place the custom_components folder in your configuration directory (or add its contents to an existing custom_components folder).

Configuration

This integration does not support config flows yet, so you need to add it in configuration.yaml:

binary_sensor:
  - platform: dlink_hnap
    name: Kitchen Motion
    host: 10.0.0.10
    type: motion
    username: Admin
    password: 123456
    timeout: 35
  - platform: dlink_hnap
    name: Kitchen Leakage
    host: 10.0.0.11
    type: water
    username: Admin
    password: 123456

Here are the configuration options:

key	optional	type	default	description
name	True	string	D-Link Motion Sensor	Name for the sensor
type	False	string		Sensor type: motion or water
host	False	string		IP address to sensor
username	True	string	Admin	Username for authentication (always Admin)
password	False	int		PIN code written on the device
timeout	True	int	35	Amount of seconds before sensor going to off after last motion (only used when type is motion)