You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Create and checkout a new branch for Lab Module 11
Review the README
Please see README.md for further information on, and use of, this content.
License for embedded documentation and source codes: PIOT-DOC-LIC
Estimated effort may vary greatly
The estimated level of effort for this exercise shown in the 'Estimate' section below is a very rough approximation. The actual level of effort may vary greatly depending on your development and test environment, experience with the requisite technologies, and many other factors.
Actions
On the command line, you can simply run:
git checkout -b labmodule11
Estimate
This should take less than 10 minutes
Tests
Run git branch. You'll see the following branches listed:
primary
labmodule01
labmodule02
labmodule05
labmodule07
labmodule08
labmodule10
labmodule11
Unit tests
All part01, part02, and part03 unit tests should pass.
Integration tests
All part01, part02, and part03 integration tests should pass.
The text was updated successfully, but these errors were encountered:
labbenchstudios
changed the title
PIOT-GDA-11-000: Create and checkout a new branch for Chapter 11
PIOT-GDA-11-000: Create and checkout a new branch for Lab Module 11
Dec 26, 2020
Description
Review the README
Estimated effort may vary greatly
Actions
git checkout -b labmodule11
Estimate
Tests
git branch
. You'll see the following branches listed:part01
,part02
, andpart03
unit tests should pass.part01
,part02
, andpart03
integration tests should pass.The text was updated successfully, but these errors were encountered: