You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Firmware: 4.0.1-final+1974
(from shipped stick, latest release from GH does not trigger an update)
Browser: Firefox 71.0 on Linux
Hardware: Prusa Mini + Filament Sensor
Steps to reproduce:
Boot up printer
Let an IP get assigned
Open http://<ip of printer>/ in browser
Experience crash and fan spin-up on printer while getting only a partial website
Note:
In some cases the site gets loaded without image but with stylesheet
Most times the site looks like displayed below
After reset on crash the (broken) website can refresh temperatures without issues
Possibly related to / duplicate of Fatal crash during printing (x2) #18 but in my case not related to an active print but occurring after freshly starting the printer without any print task, therefore opening a separate issue for this
Trace:
Website:
The text was updated successfully, but these errors were encountered:
Perhaps I should also mention that a jumper was sent after me. I haven't put it in because I don't use custom firmware. Is it possible that I still need to place it somewhere?
Setup:
4.0.1-final+1974
(from shipped stick, latest release from GH does not trigger an update)
Steps to reproduce:
http://<ip of printer>/
in browserNote:
Trace:
Website:
The text was updated successfully, but these errors were encountered: