You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
My MK2 and my MK3 display their current Z-height while printing - this is convenient, especially when expecting a pause for nut/magnet insertion or filament change. My MK4 does not. I know I can see it on the dashboard, but often my computer is off while I am printing.
Please include this display with the next firmware upgrade.
It is possible that this feature is available - but if so I have been unable to turn it on - therefore it is badly indexed in that searches do not reveal how to enable it.
In this case please make it easier to find.
The text was updated successfully, but these errors were encountered:
My MK2 and my MK3 display their current Z-height while printing - this is convenient, especially when expecting a pause for nut/magnet insertion or filament change. My MK4 does not. I know I can see it on the dashboard, but often my computer is off while I am printing.
Please include this display with the next firmware upgrade.
It is possible that this feature is available - but if so I have been unable to turn it on - therefore it is badly indexed in that searches do not reveal how to enable it.
In this case please make it easier to find.
The text was updated successfully, but these errors were encountered: