You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
3D printer brand / version + firmware version (if known)
3.8
Behavior
When using the or Arrange Function within Prusa Slicer if you put a lot of objects / Large Objects on the bed it does not account for the brim and so organizes the objects without accounting for the brim causing an error that you are attempting to print outside of the available space. Is this a new feature request?
The text was updated successfully, but these errors were encountered:
You can temporarily make the plater smaller in the printer settings and arrange the objects for the smaller plater. After that reset to your actual plater size and move the objects around so that they are in the middle again.
Version
Prusa Slicer 2.1.0
Operating system type + version
Windows 10
3D printer brand / version + firmware version (if known)
3.8
Behavior
When using the or Arrange Function within Prusa Slicer if you put a lot of objects / Large Objects on the bed it does not account for the brim and so organizes the objects without accounting for the brim causing an error that you are attempting to print outside of the available space.
Is this a new feature request?
The text was updated successfully, but these errors were encountered: