-
Notifications
You must be signed in to change notification settings - Fork 1.9k
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
[Feature Request] Enable Wipe Tower with Repetier-Firmware #1310
Comments
We did not test with the Repetier firmware, therefore we did not allow that. There is some hard-coded G-code generated by the wipe tower generator, and we did not evaluate whether this G-code is compatible with Repetier. We may consider to provide you with a test build first for you. |
i will gladly test that out for you |
by the way, i tried printing with prime tower using RepRap flavor on a printer with repetier-fw and it completed without errors. |
ok, we will enable that in the next release (1.42).
…On Wed, Oct 24, 2018 at 6:55 PM Braccoz ***@***.***> wrote:
by the way, i tried printing with prime tower using RepRap flavor on a
printer with repetier-fw and it completed without errors.
—
You are receiving this because you commented.
Reply to this email directly, view it on GitHub
<#1310 (comment)>,
or mute the thread
<https://github.com/notifications/unsubscribe-auth/AFj5Iw-OUvhG0S2Q3GTNknnrnKOvTdJiks5uoJtqgaJpZM4XXZt2>
.
|
Implemented with b856775 |
Version
1.41.0
Operating system type + version
Windows 7 X64
Behavior
Wipe Tower is only compatible with Marlin and RepRap/Sprinter firmware settings, selecting Repetier will throw the error
" Configuration is not valid: The Wipe Tower is currently only supported for the Marlin and RepRap/Sprinter G-code flavors."
i don't see any reason why the wipe tower would not be compatible with repetier fw. It supports relative extruder moves.
The text was updated successfully, but these errors were encountered: