Open source eurorack hardware using an ESP32.
ESP32 acts like anything you want, just reprogram with new firmware.
- Analogue input x4
- 1/8" jack x3 (IN0, IN1, IN2)
- 2.54mm pin header x2 (IN2, IN3)
- Analogue output x4
- 1/8" jack x3 (OUT0, OUT1, OUT2)
- 2.54mm pin header x3 (OUT2, OUT3)
- Potentiometer input x4
- Tactile switch x2
- Feedback resistor (digital pot connecting OUT0 to IN0)
- Digital pot output on 2.54mm pin header
- Dry/wet mixer (IN0 + OUT0 - connecting to digital pot)
- WS2812B LEDs x2
- Eurorack standard 10 pin IDC connector
- 12V input
- ESP-IDF or Arduino