PiGlow sample code and instructions

PiGlow is a small add on board for the Raspberry Pi that provides 18 individually controllable LEDs. You can use it for all sorts of things! And of course, it fits inside a Pibow!

Setting up your Raspberry Pi

PiGlow is based on an IC that communicates via i2c protocol. We need to enable i2c communication on your Raspberry Pi for it to work.

Enable the i2c driver modules by editing the modules config file:

sudo nano /etc/modules

Then either add or ensure the following lines are at the end of the file:

i2c-dev
i2c-bcm2708

You may also need to ensure the driver modules are not blacklisted by editing the blacklist config file:

sudo nano /etc/modprobe.d/raspi-blacklist.conf

Ensure that if the following two lines exist in that config file that you comment them out by adding a # sign at the start of the line. So:

blacklist spi-bcm2708
blacklist i2c-bcm2708

...should become...

# blacklist spi-bcm2708
# blacklist i2c-bcm2708

Then we install the i2c libraries and Python support:

sudo apt-get install python-smbus

Then reboot your Pi!

Running the example Python code

Either clone this git repository or download piglow-example.py. You can then run the sample by entering:

sudo python piglow-example.py

The Python code is designed to show you how to talk to the IC on the PiGlow board so that you can extend it to do other more exciting things!

Want a specific example of how to do something? Get in touch! We should be able to knock up an example or at least point you in the right direction. Just e-mail support@pimoroni.com

Other support for PiGlow

Gordon Henderson (@drogon on Twitter) has very kindly added support for PiGlow into his very popular wiringPi library and even includes a basic command line tool that you can use to control your PiGlow! http://wiringpi.com/dev-lib/piglow/

Simon Walters (@cymplecy) has added awesome PiGlow support to his Raspberry Pi GPIO Scratch library: http://cymplecy.wordpress.com/2013/08/12/scratch-gpio-piglow-support/

Jason Barnett has put together a great Python class and a load of samples: https://github.com/Boeeerb/PiGlow

Ben Lebherz has forked Jasons project and tidied up the code a bit while adding gamma correction: https://github.com/benleb/PyGlow

Manuel Ernst has created a Node.js library: https://github.com/zaphod1984/node-piglow

More information

For more information the datasheet for the SN3218 IC is included in this repository which outlines the complete communication protocol for the chip.

For those wanting to wire up their PiGlow in other ways these are the GPIO pins used by the module:

• P1 & P17 (3V3)
• P2 (5V)
• P14 (GND)
• P3 (SDA)
• P5 (SCL)