ATTINY85 IOTA SEED Management
DIY Build of IOTA SEED Management consists of the components:
- USB-Case as a 3D Print
- ATTINY85 Digispark USB Board
- (Optional Photoresistor)
- Arduino Development Environment with ATTINY85 drivers (http://arduiono.cc)
- 2 Versions of Code
-
- Plug & Play needs only the board, add the one Seed in the code and compile (Community edition)
-
- Nine (9) Seed Version needs some small assembly of a Photoresistor and some work, provided by a Youtube video (tbd>)
Overview:
- Assembly
- Place the Board into the USB-Case (3D-Print).
- Doubleclick on the INO-File and open it.
- place your SEED into the 1st line of code (new SEED can be created here)
- compile code
- upload the code to the USB Board and add the Board to the USB Connector
- Useage
- Open your IOTA Wallet
- place the cursor to the SEED entry
- add the SeedStick
- SeedStick fills in the SEED
- Remove the SeedStick (dont't forget)
- Only at 1st Useage: write the 3 letter shortcode (Wallet output) of the SEED onto this new build SeedStick case (to identify which Stick is the right one if there are several)
- Problems
- if you add the SeedStick the SEED will be placed anywhere where the cursor is located
- Be always sure that your cursor is where the SEED should be inserted.
- Safety
- Add the SeedStick to insert the SEED, remove the SeedStick immediately
- Keep complete Github repository and Arduino INO - Files on a USB-Stick and execute:
-
- download and run Arduino from a USB Stick
-
- then close your network
-
- add SEED to code
-
- compile and upload code to SeedStick
-
- remove SeedStick and close, remove the Arduino environment incl. USB Stick
-
- connect, open to your network
-
- open IOTA Wallet, place cursor to the SEED entry
-
- test and use it: stick the SeedStick to a USB port and wait 1-2 seconds to fill in
-
- remove SeedStick
- Be happy
- Handling the Arduino environment
- Where to buy