mysensors-watermeter

Sketch to read pulses from pulse meter; Only accepts a pulse change if the signal has been stable for more than x seconds; Only sends message to gateway after more than x seconds have passed since sending last message; Pulses are assumed to equal 1 liter of water

• Author Sandor Incze & Michel Schilthuizen
• Created 2016-05-29 Version 1.0
• Created 2018-01-28 Version 1.1 *Mysensors 2.0+ Compatible)

Based on the flow reader sketch "WaterMeterPulseSensor" by Henrik Ekblad henrik.ekblad@mysensors.org Copyright (C) 2013-2015 Sensnology AB Full contributor list: https://github.com/mysensors/Arduino/graphs/contributors

During testing in can be handy to be able to set the values in domoticz; You can do this by using the REST request below: (replace x.x.x.x and deviceid by relevant numbers

• http://x.x.x.x:8080/json.htm?type=command&param=udevice&idx=deviceid&nvalue=0&svalue=0

This sketch was designed because of the enormous amount of false interrupts we received from the TCRT-5000 And is a modified version of the isrcounter.c we found for the same radio module used with a raspberry.

• https://www.mysensors.org/build/pulse_water
• Follow wiring instructions here: https://www.mysensors.org/temp/APM_D3.png

•                                  https://www.mysensors.org/water/doao.png