Skip to content

Latest commit

 

History

History
36 lines (25 loc) · 1.49 KB

debug_probes.md

File metadata and controls

36 lines (25 loc) · 1.49 KB

Compatible CMSIS-DAP debug probes

Raspberry Pi Pico

You can use a second Pico as your debugger.

  1. Download official Raspberry PI probe firmware file picoprobe.uf2
  2. Put the Pico into USB Mass Storage Mode by holding the BOOTSEL button while connecting it to your computer with a USB cable
  3. Open the drive RPI-RP2 when prompted
  4. Copy the uf2 firmware file from Downloads into RPI-RP2
  5. Connect the debug pins of your CMSIS-DAP Pico to the target one
    • Connect GP2 on the Probe to SWCLK on the Target
    • Connect GP3 on the Probe to SWDIO on the Target
    • Connect a ground line from the CMSIS-DAP Probe to the Target too

WeAct MiniF4

https://therealprof.github.io/blog/usb-c-pill-part1/

HS-Probe

https://github.com/probe-rs/hs-probe

ST-LINK v2 clone

It's getting harder to source these with stm32f103's as time goes on, so you might be better off choosing a stm32f103 dev board

Firmware: https://github.com/devanlai/dap42

LPC-Link2

https://www.nxp.com/design/microcontrollers-developer-resources/lpc-link2:OM13054

MCU-Link

https://www.nxp.com/part/MCU-LINK#/

DAPLink

You can use DAPLink firmware with any of it's supported chips (LPC4322, LPC11U35, K20, K22, KL26). You'll need to use the 'develop' branch to use GCC to build it. You'll need to find a chip with the correct

Firmware source: https://github.com/ARMmbed/DAPLink/tree/develop