New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Jump to bottom

Endstop voltage selection needs to match pullup #36

Open

Ccecil opened this issue Nov 26, 2022 · 0 comments

Collaborator

Ccecil commented Nov 26, 2022

Currently, the pullup is tied to 3.3v and the endstop pin 1 is tied to 5v by default but is switchable to 3.3v via jumper.

If we tie the pullup resistor to pin 1 on each connector instead of 3.3v this will allow the voltages to match based on what is selected via jumper.

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment