Possible problem with the saving of pm5s files (Layer Exposure is set to 0s) #757
-
|
Hy there, |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 8 replies
-
|
Here is a zip file with one unedited and one edited version. If the 0s problem exists in the unedited one i can not say, since i did not print it due to the resin traps... |
Beta Was this translation helpful? Give feedback.
-
|
Ok I tried to slice something else and edit it like the files above. And as it seems, it's working. So maybe it's the STL files? Should I send you the STL and lys files too? |
Beta Was this translation helpful? Give feedback.
-
|
Both files look correct, but one has per layer settings on which can causing trouble #742 |
Beta Was this translation helpful? Give feedback.
-
|
Great, thank you very much! I looked at the other files that I had issues with, and at least one has not set the perlayer flag. I reset the layer setting nonetheless and will try to print it. Maybe it works anyway. Will report back! |
Beta Was this translation helpful? Give feedback.
-
|
Ok and it failed again with the first layer still in the vat... was not the file I send you, but had failed before and showed the layer issue you mentioned, which I corrected with your workaround. Seems it did not help for my problem(s)... sorry to bother you again! Should I upload this file too? |
Beta Was this translation helpful? Give feedback.
-
|
Try to print the file without modify with UVtools |
Beta Was this translation helpful? Give feedback.
-
|
Ok, it failed also. It's not only or even at all a problem of UVTools. But on the other hand, I successfully printed a file just the other day with the same settings!?! It was an stl that I pulled presupported of thingyverse but had a .lys file included were i edited the supports a bit. Idk anymore what to do at this point... |
Beta Was this translation helpful? Give feedback.
-
|
If print is failing stuck on fep it may be settings or poor surface quality. If machine itself is the problem, try to update firmware first. |
Beta Was this translation helpful? Give feedback.
-
|
Ok. so i think i found a solution to my peticular problem. I used very large files in hope of getting fine details, but seems that messed lychee up in some way. If i reduce the files with 3d Builder by 1 level, use UVTool to my full advantage, and reset the layer thingy: i can print... at least one model. I just started the big one with 2 models +2 bases and will see in 11h whats behind my theorie. Thank you again for looking into it!! |
Beta Was this translation helpful? Give feedback.
-
|
Ok it works, it seems i just need to work on my supporting skills ;) |
Beta Was this translation helpful? Give feedback.
Both files look correct, but one has per layer settings on which can causing trouble #742