You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
As the Support Z-Offset can ONLY be a multiple of the layer height, modify the Entry of support Z Offset value so that values are restricted to that. If the layer Height is .3mm the Z-Separation can't be .2 or .4, but only .3 or .6mm. A .15 layer can only have .15 or .30 or .45 etc...
Raft Separation should ALSO be this way
This MAY help with support removal as setting the Z-Height to something other than a multiple of layer height may result in stubborn supports.
Is this a new feature request?
Yes
Project File (.3MF) where problem occurs
Upload a Project File (.3MF) Plater -> Save Project as... You have to zip it (or rename it to .zip) to be able to drag& drop it here
The text was updated successfully, but these errors were encountered:
The support z can be and IS different from the layer height. ALL supports are sliced with an independent layer height normally and have been since forever. Its why if you slice a model with supports enabled you end up with a greater layer count than you would expect. The slicer makes that decision and it doesn't even obey the limits for layer height set in the extruder settings.
On Thu, Oct 6, 2022 at 7:18 PM neophyl ***@***.***> wrote:
The support z can be and IS different from the layer height. ALL supports
are sliced with an independent layer height normally and have been since
forever. Its why if you slice a model with supports enabled you end up with
a greater layer count than you would expect. The slicer makes that decision
and it doesn't even obey the limits for layer height set in the extruder
settings.
—
Reply to this email directly, view it on GitHub
<#3321 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AFJ2GY7WSHVZVVZ23QB4DSDWB5M2PANCNFSM6AAAAAAQ6U74ZA>
.
You are receiving this because you authored the thread.Message ID:
***@***.***>
--
-----------------------------------------------------------------------------------
Need a quick answer? Call our booking line at (301) 208-8289, or book your
inspection on our website 24/7.
Don't wait for a response as someone else may get the spot you want... call
Today!
-----------------------------------------------------------------------------------
Bob Sisson, ACI, BVI
Inspections by Bob, LLC
www.inspectionsbybob.com
***@***.***
MD Lic#29666; ASHI Member #212016
Version
2.4.58.5
Operating system type + version
NA
Behavior
As the Support Z-Offset can ONLY be a multiple of the layer height, modify the Entry of support Z Offset value so that values are restricted to that. If the layer Height is .3mm the Z-Separation can't be .2 or .4, but only .3 or .6mm. A .15 layer can only have .15 or .30 or .45 etc...
Raft Separation should ALSO be this way
This MAY help with support removal as setting the Z-Height to something other than a multiple of layer height may result in stubborn supports.
Is this a new feature request?
Yes
Project File (.3MF) where problem occurs
Upload a Project File (.3MF)
Plater -> Save Project as...
You have to zip it (or rename it to .zip) to be able to drag& drop it here
The text was updated successfully, but these errors were encountered: