-
Notifications
You must be signed in to change notification settings - Fork 0
1. Install Cisco ATA
You should start with the configuration file SPA232D_1.4.0.cfg in the directory ATA.
Connect your computer using ethernet with the ATA, use the port ETHERNET(yellow). Open the administration page at http://192.168.15.1 and login with the user admin and password admin.
Navigate to “Administration”, “Config Management”, “Restore Configuration” und upload the file \cmdi{SPA232D_1.4.0.cfg}.
There are many settings to configure. If you don't have spare time, you should use the quick installation.
Connect your computer using ethernet with the ATA, use the port ETHERNET(yellow). Open the administration page at http://192.168.15.1 and login with the user admin and password admin.
Make the following configuration in “Voice”, “Regional”
Miscellaneous: Caller ID Method = ETSI FSK (or you can try ETSI DTMF alternatively).
Make the following configuration in “Voice, “PSTN”
IP address of the asterisk SIP server and the login:
- Proxy and Registration: Proxy = 192.168.15.50
- Subscriber Information: User ID = spa232d-pstn
- Subscriber Information: Password = spa232d-pstn
Call the IP 192.168.15.50 immediately:
- Dial Plans: Dial Plan 1 =
(S0<:100@192.168.15.50>)
Outgoing calls from asterisk and line1 don't need a dialplan:
- VoIP-To-PSTN Gateway Setup: VoIP Caller Default DP = none
- VoIP-To-PSTN Gateway Setup: Line 1 VoIP Caller DP = none
For incoming calls the dialplan 1 is used. While connecting to asterisk the call is not picked up ("off hook"). Incoming calls are filtered, the star forces loading the caller id:
- PSTN-To-VoIP Gateway Setup: PSTN Caller Default DP = 1
- PSTN-To-VoIP Gateway Setup: VoIP Caller ID Pattern = *
- PSTN-To-VoIP Gateway Setup: Off Hook While Calling VoIP = no
Wait 1 second until calling asterisk, in order to ensure that the caller id is loaded.
- PSTN Timer Values: PSTN Answer Delay = 1 PSTN Timer Values : PSTN Ring Thru Delay = 3
Pattern make settings according to your country:
- PSTN Disconnect Detection: Disconnect Tone = 425@-15,425@-15;4(.5/.5/1+2)
- International Settings: FXO Country Setting: Switzerland
Make the following configuration in “Voice, “Line 1”
IP address of the asterisk SIP server and the login:
- Proxy and Registration: Proxy =
192.168.15.50 - Subscriber Information: User ID =
spa232d-line1 - Subscriber Information: Password =
spa232d-line1
Outgoing calls should go to landline, special calls go to asterisk: -Dial Plan: Dial Plan = (xx[0-9#].<:@192.168.15.50>|xx.<:@gw0>)
Make the following configuration in “Network Setup”
Basic Setup: Network Service : Networking Service = Bridge
Set the time zone:
- Basic Setup: Time Settings: Time Zone = GMT+01
Make the following configuration in “Administration”
In “Management”, “User List” open the user admin. Change the password.
In “Management”, “Web Access Management” activate remote access
Remote access allows to configure the ATA over the "INTERNET" port.
Connect the cables, you can use the ETHERNET Port of the ATA to connect the raspberry pi. The ATA uses DHCP to configure the IP address.