-
I'm ready to calibrate my Atlas-Scientific pH and ORP probes. I have the Gen 3 probes so the pH probe does not provide temperature--I plan to use the pool water temperature thermister to send the temperature to the EZO-pH circuit. I set up a feed from the temperature thermister to forward to Internal Devices in degrees Centigrade as in the Wiki and shown below. On the EZO-pH device page, however, the magnintude of the temperature displayed is the Fahrenheit temperature, but it shows degrees Centigrade, see below. What am I doing incorrectly? Thank you! |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
I think I figured it out. I changed the feed from the thermister to be temperature Fahrenheit instead of Centigrade and it looks like the EZO-pH does the conversion to Centigrade automatically, as below. Now on to calibration of the probes :-) |
Beta Was this translation helpful? Give feedback.
I think I figured it out. I changed the feed from the thermister to be temperature Fahrenheit instead of Centigrade and it looks like the EZO-pH does the conversion to Centigrade automatically, as below. Now on to calibration of the probes :-)