You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I've been printing my parts in PETG rather than ABS like I've done most of my external parts but I've noticed that the holes for the pins on the handle are rather tight, I have to hammer them in. They also like to go in at an angle which often results in me splitting the part. adding a slop cutout to the parts would help alleviate this
The text was updated successfully, but these errors were encountered:
I've been printing my parts in PETG rather than ABS like I've done most of my external parts but I've noticed that the holes for the pins on the handle are rather tight, I have to hammer them in. They also like to go in at an angle which often results in me splitting the part. adding a slop cutout to the parts would help alleviate this
The text was updated successfully, but these errors were encountered: