Replies: 17 comments 37 replies
-
Beta Was this translation helpful? Give feedback.
-
look what happened to the feed rate :/ |
Beta Was this translation helpful? Give feedback.
-
Wow, that's quite a machine, 257 KPH! |
Beta Was this translation helpful? Give feedback.
-
I'm thinking it's some error or bug in the program. how would i go about getting some error log. Would ? |
Beta Was this translation helpful? Give feedback.
-
log.txt |
Beta Was this translation helpful? Give feedback.
-
<Run|MPos:0.000,0.000,0.520|Bf:34,1023|FS:4294967295,0> |
Beta Was this translation helpful? Give feedback.
-
next try :/ [G58:0.000,0.000,0.000] |
Beta Was this translation helpful? Give feedback.
-
I need your settings to investigate this. |
Beta Was this translation helpful? Give feedback.
-
New Error :/ This error happened when I clicked on the GRBL tab after defining the parameters in the Height Map tab error log file attached |
Beta Was this translation helpful? Give feedback.
-
Is the last error repeatable? And there is a different error message behind the OutOf MemoryException box, what is/was it? FYI there is a newer edge version available, can you try with that? |
Beta Was this translation helpful? Give feedback.
-
I managed to simulate the error frequently, I think you will also be able to simulate it there. I believe this error is a bug, I have already updated to version 2.00.44p4 as you suggested. First I import the .tap file, then I go to the "probing" tab, sub-tab "Tool length offset". I start the test to capture the zero point on the Z axis, after completing it I go to ava GRBL, when I do this this error occurs. If I go directly to the "Height map" subtab and start the survey, this error does not occur. I think the problem is leaving the survey tab and going to the GRBL tab after having already started the process of capturing the zero point of the z axis in the "tool length offset" tab and the situation gets worse if I lower the feed rate values, reduce these values. :/ |
Beta Was this translation helpful? Give feedback.
-
Tomorrow I'll try with the ioSender XL Edge 2.0.44p4.zip version I even changed computers, I have another more powerful computer using Windows 10 Pro, where I recorded these videos above |
Beta Was this translation helpful? Give feedback.
-
Out of memory exception: I wonder if this is due to the resident guru in the ESP32 outputting garbage on connect: I see that you have No action selected for On connect in the sender connection dialog so this garbage should not appear. I'll investigate this, it could be that I have to flush the input buffer on startup. |
Beta Was this translation helpful? Give feedback.
-
I tried the XL version. The error appeared after finishing the surface scan, this time I didn't click on anything. |
Beta Was this translation helpful? Give feedback.
-
I have upload a new edge version with some minor changes. However, after running numerous tests with your file I have yet to see any exceptions so it impossible for me to pin down where it goes wrong for you. |
Beta Was this translation helpful? Give feedback.
-
Good luck with Mach3 then. |
Beta Was this translation helpful? Give feedback.
-
Good morning everyone, first forgive me if I can't be clear, my English is weak so I'm using the google translator, I'm from Brazil.
I have the following problem. During the probing process, the IO Sender is crashing, it simply stops or even goes to the end but does not show the vector drawing with the scanned points. I'll put some images on the IO sender. Do you have any logs to review? I'm using the latest version 2.0.43.
NOTE: My probe (milling cutter) is not touching anything and is inside the machining area (Cartesian plane) as per the print image.
Beta Was this translation helpful? Give feedback.
All reactions