-
Notifications
You must be signed in to change notification settings - Fork 20
HW Setup
Pekka Ervasti edited this page Sep 19, 2016
·
2 revisions
These instructions are for JTAG debugging utilizing Olimex ARM-USB-OCD-H:
https://www.olimex.com/Products/ARM/JTAG/ARM-USB-OCD-H/
Cable adapter:
https://www.olimex.com/Products/ARM/JTAG/ARM-JTAG-20-10/
Connect JTAG debugger to Thingsee as in picture below:
TODO Insert picture here
- Ground, UART Rx and Tx wires soldered to the Thingsee One
Check the test point specification from Thingsee One hardware specification
- FTDI USB to UART adapted cable TTL-232R-3V3
Check the cable pin order in the TTL-232R cable datasheet
TODO Insert picture here