About

Stressdrive is a Mac OS X command-line tool meant to verify correct operation of a drive. It does so by filling a drive up with random data and ensuring all the data can be correctly read back.

It was written to verify correct operation of de-duping SSDs, but it be used with normal HDDs or any rewritable block storage device.

DANGER: stressdrive will overwrite, without warning, all data on the given drive. Be sure to double-check the drive you're aiming it at (Disk Utility.app > Select Drive > Info > Disk Identifier).

Usage

sudo ./stressdrive /dev/rdrive1

Sample Run

$ sudo ./stressdrive /dev/rdisk1
blockSize: 512
blockCount: 512000
writing random data to /dev/rdisk1
writing 100% (block 511360 of 512000)
2eed7209b7a5b9a1a22cd4eb1b77a59da23c1d56 <= SHA-1 of written data
verifying written data
reading 100% (block 510323 of 512000)
2eed7209b7a5b9a1a22cd4eb1b77a59da23c1d56 <= SHA-1 of read data
SUCCESS

"How is this better than Disk Utility's 'Zero Out Data'?"

Some SSD's de-duplicate stored blocks. For these "filling" it with zeros if actually just modifying one or two actual mapping blocks over and over again. It's not a real test of the SSD's hardware.

"How is this better than Disk Utility's '7-Pass Erase'?"

Stressdrive only overwrites the drive with data once (so it's 7x faster) and then verifies all the data is correctly read back (which Disk Utility doesn't do at all).

Jens Ayton informs me 7-Pass Erase uses fixed patterns, so de-duping may be an issue there as well.

"Pshaw! I could do this with dd, /dev/random & shasum!"

Indeed you could. I prefer a minimal focused tool whose operation is fixed, its source simple+readable and offers good built-in progress reporting.

Portablity

Stressdrive should be easily portable to other Unixes if anyone wants to do that and toss me a Pull Request.