Too much informations when configuring

[Martoni]

Is it possible to have less log messages when programming the FPGA ?

 $ ./cycloader -c digilent_hs3 pouet_impl1.jed
try to open 403 6014 -1 -1
found 1 devices
idcode 0x612bd043
funder lattice
model  MachXO3LF
family LCMX03LF-6900C
jed
G0
F0
fuse checksum C5343 AA 5343
inconnu
UH00000000
end
area[0] 0 269056
area[1] 269056 1172224
theorical checksum 5343 -> 5343
array size 2102
IDCode : 612bd043
00 08 0f 10 
displayReadReg
	Config Target Selection : 0
	JTAG Active
	Done Flag
	ISC Enable
	Write Enable
	Read Enable
	SDM Enable
	No err
flash erase
00 08 0e 10 
displayReadReg
	Config Target Selection : 0
	JTAG Active
	ISC Enable
	Write Enable
	Read Enable
	SDM Enable
	No err
00 08 0f 18 
displayReadReg
	Config Target Selection : 4
	JTAG Active
	Done Flag
	ISC Enable
	Write Enable
	Read Enable
	SDM Enable
	No err
flash erase
00 00 0e 18 
displayReadReg
	Config Target Selection : 4
	JTAG Active
	ISC Enable
	Write Enable
	Read Enable
	No err
Writing: [==================================================] 100.00%
Done
00 00 0e 18 
displayReadReg
	Config Target Selection : 4
	JTAG Active
	ISC Enable
	Write Enable
	Read Enable
	No err
Verifying: [==================================================] 100.00%
Done
00 00 0e 18 
displayReadReg
	Config Target Selection : 4
	JTAG Active
	ISC Enable
	Write Enable
	Read Enable
	No err
00 00 0e 18 
displayReadReg
	Config Target Selection : 4
	JTAG Active
	ISC Enable
	Write Enable
	Read Enable
	No err
00 00 00 00 00 00 00 00 
0600
	boot mode                                : Single Boot from NVCM/Flash
	Master Mode SPI                          : disable
	I2c port                                 : disable
	Slave SPI port                           : disable
	JTAG port                                : enable
	DONE                                     : disable
	INITN                                    : disable
	PROGRAMN                                 : enable
	My_ASSP                                  : disable
	Password (Flash Protect Key) Protect All : Disabled
	Password (Flash Protect Key) Protect     : Disabled
00 00 0e 18 
displayReadReg
	Config Target Selection : 4
	JTAG Active
	ISC Enable
	Write Enable
	Read Enable
	No err
00 08 0f 18 
displayReadReg
	Config Target Selection : 4
	JTAG Active
	Done Flag
	ISC Enable
	Write Enable
	Read Enable
	SDM Enable
	No err
00 08 01 00 
displayReadReg
	Config Target Selection : 0
	Done Flag
	SDM Enable
	No err
00 08 01 00 
displayReadReg
	Config Target Selection : 0
	Done Flag
	SDM Enable
	No err

[Martoni]

Fixed with 8d0bfeb
thanks