Arduino library for the MIC184 Temperature Sensor

Library based on the LM75 Libray by Elektronik Hannes Jochriem, Germany
See https://github.com/ehajo/LM75B

Please see examples for further usage of it.

License

(C) 2021 venice

This library is open source and released under MIT license. Please see this file for further information.

MIC184

The chip is fully LM75 comatible and communicates via I2C and converts the temperature every 10ms in 11bit resolution (0.125°).
The standard I2C address is 0x48, you can configure three bits (A0, A1, A2) on the Addon-Board to use up to 7 boards.
This gives an extended Address range of:
Binary: 0 1 0 0 1 A2 A1 A0
Hex: 0x48 to 0x4F

Power-up condition

After power-up following register settings are default:

• Normal operation mode
• OS comparator mode
• T_th(ots) = 80°C
• T_hys = 75°C
• OS output active state is LOW
• Pointer value is logic 00 (Temp)

Functions in the library

void setAddress(uint8_t bit_A0, uint8_t bit_A1, uint8_t bit_A2)

Set the address if you use something different for A0-A2

float getTemp()

Returns the temperature as float value in °C.

float CtoF(float temperatureC)

You can use this to convert the temperature from °C to °F (I have no idea why you should to this...)

float getTOS()

Returns the Temperature overshoot temperature stored in the Tos-register.

void setTOS(float temperature)

Sets the Temperature overshoot temperature. This register is compared with the temp-register after each conversion to set OS-pin.

float getHyst()

Returns the Hysteresis temperature stored in Thyst-register

void setHyst(float temperature)

Sets the Hysteresis temperature register. This register is compared after each conversion, if temp-register < Thyst than OS-pin is set.

void setMode(MIC184_opmode opmode)

This is used to send the device in Shutdown-mode. Available MIC184_opmodes are:

• MIC184_MODE_NORMAL (default)
• MIC184_MODE_SHUTDOWN

void setOSMode(MIC184_OS_opmode opmode)

The OS-opmode defines how the device handles Tos and Thyst events. Available MIC184_OS_opmodes are:

• MIC184_OS_COMPARATOR (default)
• MIC184_OS_INTERRUPT

void setTOSPolarity(MIC184_TOSPolarity polarity)

Defines if the polarity of OS-pin is high or low after TOS-event. Available MIC184_TOSPolarities are:

• MIC184_OSPOL_LOW (default)
• MIC184_OSPOL_HIGH

void setOSFaultQueue(MIC184_OS_Fault_queue numberfaults)

The fault queue is defined as the number of faults that must occur consecutively to activate the OS output. Available MIC184_OS_Fault_queues are:

• MIC184_FAULTS_1
• MIC184_FAULTS_2
• MIC184_FAULTS_4
• MIC184_FAULTS_6

void setZONE(MIC184_zone zone)

Set the active Temperature Zone.
Available MIC184_ZONE's are:

• MC184_ZONE_INTERNAL (default)
• MIC184_ZONE_REMOTE