-
Notifications
You must be signed in to change notification settings - Fork 5
amp trace
amp-trace - AMP standalone UDP traceroute test
amp-trace [-abhrx] [-p milliseconds] [-s packetsize] [-w window] [-I iface] [-4 address] [-6 address] [-Q codepoint] [-Z microseconds] -- destination1 [destination2 ...]
amp-trace is the standalone version of the amplet2(8) UDP traceroute test. It is very similar in function to traceroute(1), except that it can test to multiple destinations simultaneously. All destinations listed on the command line will be tested to. Any destinations that are hostnames will be resolved, and every address that they resolve to will be tested.
-a, --asn Lookup AS numbers for all addresses using http://www.team-cymru.org/IP-ASN-mapping.html. Please be respectful of the demands that this places on their infrastructure and use their service appropriately. Any large deployments that will use this test option should contact Team Cymru directly.
-b, --noip Don't report IP addresses for each hop in the path.
-h, --help Show summary of options.
-I, --interface iface
Specifies the interface (device) that tests should use when sending
packets. By default the interface will be selected according to the
routing table.
-p, --perturbate milliseconds
Delay the test by a random number of milliseconds, up to a maximum of
milliseconds. The default is to not perturbate tests (no delay).
-Q, --dscp codepoint
IP differentiated services codepoint to set. This should be a string
representing a 6-bit value in binary, octal, decimal or hexadecimal, or the
short name of a predefined, commonly used codepoint. The default is 0.
-r, --random Use a random packet size for each test.
-s, --size packetsize
Specifies the total number of bytes to be sent per packet (including
headers). The default is 60 bytes.
-w, --window count
Maximum number of targets to probe at one time. Only one probe will be
outstanding for each target, so this number is also the total number of
packets that can be put on to the network at any one time until a loss
timeout occurs or a response is received. The default is 50.
-v, --version Show version of program.
-x, --debug Enable extra debugging output.
-Z, --interpacketgap microseconds
Minimum number of microseconds between sending probe/query packets.
-4, --ipv4 a.b.c.d
Specifies the source IPv4 address that tests should use when sending
packets to IPv4 targets. This address must belong to one of the
interfaces. By default the IPv4 address of the outgoing interface will
be used.
-6, --ipv6 a:b:c:d:e:f:g:h
Specifies the source IPv6 address that tests should use when sending
packets to IPv6 targets. This address must belong to one of the
interfaces. By default the IPv6 address of the outgoing interface will
be used.
amplet2(8), amplet2-remote(8), amp-icmp(8), amp-dns(8), amp-throughput(8), amp-http(8), amp-tcpping(8), amp-udpstream(8).
amp-trace requires raw socket access to run.
amp-trace was written by Brendon Jones <brendonj@waikato.ac.nz>.
This manual page was written by Brendon Jones <brendonj@waikato.ac.nz>.