FT Night Radian LED Controller

Configuration:

The firmware comes set up for the FT Night Radian by default. If you have a different layout of LED strips, you can use the LED Controller Configurator to create a new layout.

After configuring, you can download the whole firmware plus config, or just the config to apply to an already-flashed board (assuming the flashed firmware is a compatible version).

Note: v2 boards allow configuring both the layout and the enabled/disabled shows directly from the configurator page. v1 boards only allow layout configuration. You can still enable/disable shows on both boards using the buttons.

---

Flashing:

v2 boards:

• Download the .uf2 file (from the latest release, or from the configurator page)
• Hold down the "Boot" button on the board while plugging it in to your computer via USB
• Drag-and-drop or copy/paste the .uf2 file into the "RPI-RP2" drive that shows up

v1 boards:

• Download the .hex file (from the latest release, or from the configurator page)
• Download and run the HEX Uploader to upload the .hex file to your board

---

Libraries used

BMX280 library from https://github.com/Erriez/ErriezBMX280 (v1.0.1)
FastLED library from https://github.com/FastLED/FastLED (v3.6.0)