You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
wuyuanyi135 edited this page Oct 7, 2020
·
1 revision
To use laser as light source, un-wire the 12V power supply to the board. Then, connect the jump header (left, farthest from the buck converter) to the +12V power supply. This will make the MOS output 5V instead of 12V when activated. If necessary, write toggle_polarity\n and then 'commit\n` to flip the polarity.