net: dsa: Introduce driver for NXP SJA1105 5-port L2 switch

At this moment the following is supported:
* Link state management through phylib
* Autonomous L2 forwarding managed through iproute2 bridge commands.

IP termination must be done currently through the master netdevice,
since the switch is unmanaged at this point and using
DSA_TAG_PROTO_NONE.

Signed-off-by: Vladimir Oltean <olteanv@gmail.com>
Signed-off-by: Georg Waibel <georg.waibel@sensor-technik.de>
Acked-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

MAINTAINERS

@@ -11120,6 +11120,12 @@ S:	Maintained
 F:	Documentation/devicetree/bindings/sound/sgtl5000.txt
 F:	sound/soc/codecs/sgtl5000*
 
+NXP SJA1105 ETHERNET SWITCH DRIVER
+M:	Vladimir Oltean <olteanv@gmail.com>
+L:	linux-kernel@vger.kernel.org
+S:	Maintained
+F:	drivers/net/dsa/sja1105
+
 NXP TDA998X DRM DRIVER
 M:	Russell King <linux@armlinux.org.uk>
 S:	Maintained

drivers/net/dsa/Kconfig

@@ -51,6 +51,8 @@ source "drivers/net/dsa/microchip/Kconfig"
 
 source "drivers/net/dsa/mv88e6xxx/Kconfig"
 
+source "drivers/net/dsa/sja1105/Kconfig"
+
 config NET_DSA_QCA8K
 	tristate "Qualcomm Atheros QCA8K Ethernet switch family support"
 	depends on NET_DSA

drivers/net/dsa/Makefile

@@ -18,3 +18,4 @@ obj-$(CONFIG_NET_DSA_VITESSE_VSC73XX) += vitesse-vsc73xx.o
 obj-y				+= b53/
 obj-y				+= microchip/
 obj-y				+= mv88e6xxx/
+obj-y				+= sja1105/

drivers/net/dsa/sja1105/Kconfig

@@ -0,0 +1,16 @@
+config NET_DSA_SJA1105
+tristate "NXP SJA1105 Ethernet switch family support"
+	depends on NET_DSA && SPI
+	select PACKING
+	select CRC32
+	help
+	  This is the driver for the NXP SJA1105 automotive Ethernet switch
+	  family. These are 5-port devices and are managed over an SPI
+	  interface. Probing is handled based on OF bindings and so is the
+	  linkage to phylib. The driver supports the following revisions:
+	    - SJA1105E (Gen. 1, No TT-Ethernet)
+	    - SJA1105T (Gen. 1, TT-Ethernet)
+	    - SJA1105P (Gen. 2, No SGMII, No TT-Ethernet)
+	    - SJA1105Q (Gen. 2, No SGMII, TT-Ethernet)
+	    - SJA1105R (Gen. 2, SGMII, No TT-Ethernet)
+	    - SJA1105S (Gen. 2, SGMII, TT-Ethernet)

drivers/net/dsa/sja1105/Makefile

@@ -0,0 +1,8 @@
+obj-$(CONFIG_NET_DSA_SJA1105) += sja1105.o
+
+sja1105-objs := \
+    sja1105_spi.o \
+    sja1105_main.o \
+    sja1105_clocking.o \
+    sja1105_static_config.o \
+    sja1105_dynamic_config.o \

drivers/net/dsa/sja1105/sja1105.h

@@ -0,0 +1,138 @@
+/* SPDX-License-Identifier: GPL-2.0
+ * Copyright (c) 2018, Sensor-Technik Wiedemann GmbH
+ * Copyright (c) 2018-2019, Vladimir Oltean <olteanv@gmail.com>
+ */
+#ifndef _SJA1105_H
+#define _SJA1105_H
+
+#include <linux/dsa/sja1105.h>
+#include <net/dsa.h>
+#include "sja1105_static_config.h"
+
+#define SJA1105_NUM_PORTS		5
+#define SJA1105_NUM_TC			8
+#define SJA1105ET_FDB_BIN_SIZE		4
+
+/* Keeps the different addresses between E/T and P/Q/R/S */
+struct sja1105_regs {
+	u64 device_id;
+	u64 prod_id;
+	u64 status;
+	u64 rgu;
+	u64 config;
+	u64 rmii_pll1;
+	u64 pad_mii_tx[SJA1105_NUM_PORTS];
+	u64 cgu_idiv[SJA1105_NUM_PORTS];
+	u64 rgmii_pad_mii_tx[SJA1105_NUM_PORTS];
+	u64 mii_tx_clk[SJA1105_NUM_PORTS];
+	u64 mii_rx_clk[SJA1105_NUM_PORTS];
+	u64 mii_ext_tx_clk[SJA1105_NUM_PORTS];
+	u64 mii_ext_rx_clk[SJA1105_NUM_PORTS];
+	u64 rgmii_tx_clk[SJA1105_NUM_PORTS];
+	u64 rmii_ref_clk[SJA1105_NUM_PORTS];
+	u64 rmii_ext_tx_clk[SJA1105_NUM_PORTS];
+	u64 mac[SJA1105_NUM_PORTS];
+	u64 mac_hl1[SJA1105_NUM_PORTS];
+	u64 mac_hl2[SJA1105_NUM_PORTS];
+	u64 qlevel[SJA1105_NUM_PORTS];
+};
+
+struct sja1105_info {
+	u64 device_id;
+	/* Needed for distinction between P and R, and between Q and S
+	 * (since the parts with/without SGMII share the same
+	 * switch core and device_id)
+	 */
+	u64 part_no;
+	const struct sja1105_dynamic_table_ops *dyn_ops;
+	const struct sja1105_table_ops *static_ops;
+	const struct sja1105_regs *regs;
+	int (*reset_cmd)(const void *ctx, const void *data);
+	const char *name;
+};
+
+struct sja1105_private {
+	struct sja1105_static_config static_config;
+	const struct sja1105_info *info;
+	struct gpio_desc *reset_gpio;
+	struct spi_device *spidev;
+	struct dsa_switch *ds;
+};
+
+#include "sja1105_dynamic_config.h"
+
+struct sja1105_spi_message {
+	u64 access;
+	u64 read_count;
+	u64 address;
+};
+
+typedef enum {
+	SPI_READ = 0,
+	SPI_WRITE = 1,
+} sja1105_spi_rw_mode_t;
+
+/* From sja1105_spi.c */
+int sja1105_spi_send_packed_buf(const struct sja1105_private *priv,
+				sja1105_spi_rw_mode_t rw, u64 reg_addr,
+				void *packed_buf, size_t size_bytes);
+int sja1105_spi_send_int(const struct sja1105_private *priv,
+			 sja1105_spi_rw_mode_t rw, u64 reg_addr,
+			 u64 *value, u64 size_bytes);
+int sja1105_spi_send_long_packed_buf(const struct sja1105_private *priv,
+				     sja1105_spi_rw_mode_t rw, u64 base_addr,
+				     void *packed_buf, u64 buf_len);
+int sja1105_static_config_upload(struct sja1105_private *priv);
+
+extern struct sja1105_info sja1105e_info;
+extern struct sja1105_info sja1105t_info;
+extern struct sja1105_info sja1105p_info;
+extern struct sja1105_info sja1105q_info;
+extern struct sja1105_info sja1105r_info;
+extern struct sja1105_info sja1105s_info;
+
+/* From sja1105_clocking.c */
+
+typedef enum {
+	XMII_MAC = 0,
+	XMII_PHY = 1,
+} sja1105_mii_role_t;
+
+typedef enum {
+	XMII_MODE_MII		= 0,
+	XMII_MODE_RMII		= 1,
+	XMII_MODE_RGMII		= 2,
+} sja1105_phy_interface_t;
+
+typedef enum {
+	SJA1105_SPEED_10MBPS	= 3,
+	SJA1105_SPEED_100MBPS	= 2,
+	SJA1105_SPEED_1000MBPS	= 1,
+	SJA1105_SPEED_AUTO	= 0,
+} sja1105_speed_t;
+
+int sja1105_clocking_setup_port(struct sja1105_private *priv, int port);
+int sja1105_clocking_setup(struct sja1105_private *priv);
+
+/* From sja1105_dynamic_config.c */
+
+int sja1105_dynamic_config_read(struct sja1105_private *priv,
+				enum sja1105_blk_idx blk_idx,
+				int index, void *entry);
+int sja1105_dynamic_config_write(struct sja1105_private *priv,
+				 enum sja1105_blk_idx blk_idx,
+				 int index, void *entry, bool keep);
+
+/* Common implementations for the static and dynamic configs */
+size_t sja1105_l2_forwarding_entry_packing(void *buf, void *entry_ptr,
+					   enum packing_op op);
+size_t sja1105pqrs_l2_lookup_entry_packing(void *buf, void *entry_ptr,
+					   enum packing_op op);
+size_t sja1105et_l2_lookup_entry_packing(void *buf, void *entry_ptr,
+					 enum packing_op op);
+size_t sja1105_vlan_lookup_entry_packing(void *buf, void *entry_ptr,
+					 enum packing_op op);
+size_t sja1105pqrs_mac_config_entry_packing(void *buf, void *entry_ptr,
+					    enum packing_op op);
+
+#endif